Home - Knowledge - Details

Precautions for the application of graphite rods in high temperature furnaces

Graphite rods have good high-temperature strength, and their strength gradually increases with the increase of temperature, which will exceed all oxides and metals, so they are often used in high-temperature furnaces. Let me tell you about the precautions for the application of graphite rods in high temperature furnaces.
1. The greater the current applied to the graphite rod, the higher the surface temperature of the graphite rod. It is recommended to use as little surface load density (power) as possible. Please note that the value recorded at the cold end of the graphite rod is the current and voltage at 1000°C in air, which may not be consistent with the actual application. Under normal circumstances, the surface power of the graphite rod is obtained from the relationship between the temperature in the furnace and the surface temperature of the graphite rod. It is recommended to use the surface power (W/cm2) of 1/2-1/3 of the limit density of the graphite rod.
2. Graphite rods should be connected in parallel as much as possible. If the graphite rods have different resistance values, the load of the graphite rods with high resistance will be concentrated when they are connected in series, resulting in a rapid increase in the resistance of a certain graphite rod and a shortened life.
3. After the graphite rod is heated in the air, a dense silicon oxide film is formed on the surface, which becomes an anti-oxidation protective film and prolongs the service life. In recent years, various coatings have been developed to prevent cracking of graphite rods and are used in furnaces with various gases. Lubricate the graphite rod.
4. The temperature distribution characteristics of graphite rods. The inspection specification for new shipments is that the effective heating length is within Δ60°C to be considered qualified. Of course, the temperature distribution will become larger as it ages, and it can eventually reach 200°C. The specific temperature distribution changes also vary depending on the atmosphere in the furnace and the operating conditions.
5. When using the graphite rod continuously, it is hoped to increase the resistance slowly to maintain a long life.
6. The life of graphite rods will be shorter as the temperature is higher. Therefore, when the furnace temperature exceeds 1400°C, the oxidation speed will accelerate and the life will be shortened. During use, try not to let the surface temperature of graphite rods be too high.

Send Inquiry

You Might Also Like